Updated November 2026

To hook up shore power to an RV, you check the campsite pedestal, confirm its amperage matches your coach, plug the cord into the pedestal first and then into your RV inlet, and verify that the power is steady before you turn on any appliances. Done in that order, the whole process takes a few minutes and keeps you clear of most of the hazards that come with campground electricity.

Before You Connect Anything

Start by reading the pedestal. Most campsites offer a 30-amp or 50-amp receptacle, and some older parks still have 20-amp outlets. Your RV’s inlet and cord must match the service you are plugging into, and a 50-amp coach needs a 50-amp site to draw its full load. If you are unsure which your coach uses, check the label near the inlet or the owner’s manual. For a deeper look at the receptacle itself, see RV Shore Power Receptacle: How to Identify, Test and Use Yours Safely (2026).

Shopping for one? See our guide: 3 Best RV Power Hook Up Kits for Campers (2026).

Make sure the RV’s main breaker or main disconnect is off, and that all major appliances, including the air conditioner, water heater and microwave, are switched off as well. This keeps the inrush of startup current from tripping the pedestal breaker.

Step-by-Step Connection Process

  1. Turn off the pedestal breaker or confirm it is off.
  2. Inspect the pedestal receptacle and your RV’s cord for cracked housings, scorched contacts or loose pins. Do not use damaged equipment.
  3. Plug the cord end into the pedestal first, pushing it fully in and twisting the locking ring if your plug has one.
  4. Connect the other end of the cord to your RV’s inlet the same way.
  5. Turn the pedestal breaker on.
  6. Switch on the RV’s main breaker or disconnect, then check your coach’s power monitor for voltage and polarity.
  7. Turn on appliances one at a time, starting with the largest loads.

Checking Power Quality

A reliable monitor shows line voltage, amperage draw and any polarity or ground fault. Typical household voltage is around 120 volts per leg on a 30-amp service and 120/240 volts on a 50-amp service. If the reading is well outside that range, or the monitor flags reversed polarity or an open ground, disconnect and move to another site or call the campground.

Managing Your Power Load

Campground pedestals share capacity with neighbors, and your RV can only draw what the site allows. A 30-amp service gives you roughly 3,600 watts, and a 50-amp service roughly 12,000 watts across both legs. Running the air conditioner, electric water heater and a space heater at once can exceed a 30-amp limit quickly.

Service Approximate Usable Capacity Common Limitation
20-amp About 2,400 watts Enough for lights, fridge and small devices only
30-amp About 3,600 watts Air conditioner and microwave together may trip the breaker
50-amp About 12,000 watts Most full-size coaches run comfortably

Common Mistakes to Avoid

  • Plugging the RV end in before the pedestal end, which leaves the cord live as you connect it.
  • Using an adapter to force a 50-amp plug into a 30-amp site without checking the load.
  • Ignoring a hot or discolored plug, which can signal a loose connection.
  • Running every appliance at once and then blaming the campground when the breaker trips.
  • Skipping a surge protector, which leaves your coach exposed to brownouts and spikes.
  • Surge protector: Monitors incoming power and cuts it off when voltage goes out of range, which protects your appliances. View on Amazon
  • Power hook up kit: A bundled set of adapters and connectors can help when your site and coach do not match. View on Amazon

FAQ

Can I plug an RV into a regular household outlet?

Yes, but only at a low load and with a proper cord. A standard 15-amp outlet is easily overloaded by an RV, so the setup is best reserved for small loads. For the full answer, see Can You Hook Up RV to House Power? Yes, Here's How.

Does shore power charge my RV batteries?

Many RVs charge their house batteries from shore power through a converter or charger. Check your coach’s manual for how it handles charging. Does Shore Power Charge RV Batteries? Yes, Here's How (2026)

What if the power goes out at the campsite?

Turn off your RV’s main breaker and appliances, then wait for the campground to restore service. Plugging back in only after the power is stable helps protect your electronics.

Conclusion

Connecting shore power comes down to matching your cord to the pedestal, making connections in the right order and checking power quality before you run anything heavy. Keep an eye on your total load and a surge protector in place, and most campsite hookups go smoothly. When in doubt about wiring or a damaged receptacle, consult a qualified electrician or RV technician.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our off-grid power for camping, RV & vanlife guides, checking product details against manufacturer specifications and owner feedback.