Updated November 2026

When RV power keeps shutting off, the cause is usually one of a few things: an overloaded circuit, a tripped breaker, a loose or failing power cord, a faulty converter, a low battery bank, or a surge protector responding to a bad pedestal. This guide walks you through checking each one in order, so you can find the problem quickly and keep your lights, fridge and fan running.

Step 1: Check the Source and the Breakers

Start at the pedestal or generator, then work inward. Confirm the campground outlet actually has power by plugging in a lamp or another device. If the pedestal is dead, the problem is outside your rig.

Shopping for one? See our guide: 4 Best RV Solar Power Air Conditioners for Off-Grid Camping in 2026.

Next, check the breakers inside your RV. Most 30-amp RVs have a main breaker at the panel and smaller breakers for individual circuits. If a breaker is in the middle position, reset it fully by pushing it to OFF and then back to ON.

Step 2: Find Out What Is Drawing Too Much Power

A 30-amp service provides roughly 3,600 watts, and a 50-amp service roughly 12,000 watts. Running an air conditioner, electric water heater and microwave together can exceed that. Turn everything off, then add loads one at a time until the power drops out. That tells you the total you can safely run.

Appliance Typical draw while running
Rooftop AC unit 1,200 to 1,500 watts (more on startup)
Electric water heater element 1,000 to 1,500 watts
Microwave 900 to 1,200 watts
Residential-style refrigerator (on AC) 150 to 300 watts while running

Figures vary by model, so check the nameplate on each appliance. Staggering heavy loads is the simplest fix.

Step 3: Inspect the Power Cord and Connections

Overheated or corroded plugs are a common cause of intermittent shutdowns. Unplug the cord and look for melted plastic, discoloration, or bent prongs. Feel the plug end after running for an hour. If it is hot to the touch, replace the cord or the inlet. Our guide to rv power cord storage covers how to keep cords clean and free of damage that leads to these failures.

Also check the pedestal itself. A loose pin or dirty contacts at the outlet can cause brief dropouts that look like a tripped breaker.

Step 4: Test the Converter and Battery Bank

If the lights flicker or shut off only when you are running on battery, the converter or batteries are the likely culprit. A converter that is failing or undersized may cut out under load, and a weak battery bank will drop below its cutoff voltage quickly. Using a multimeter, check battery voltage with everything off; a healthy 12-volt lead-acid battery reads around 12.6 volts when fully charged. For converter issues, see our walkthrough on troubleshooting an RV power converter.

Step 5: Check for a Surge Protector or Power Management System

Many modern RVs include a surge protector or power management system that disconnects power when it detects low voltage, high voltage, reversed polarity or an open ground. This is a protective feature, not a fault in the RV. If the display shows a fault code, note the code and check the manual. A protector can be the right thing to trip, even when it is inconvenient. Read more about how these devices behave in our piece on Southwire Surge Guard RV power protection.

Common Mistakes

  • Resetting a breaker repeatedly without finding the load that caused it.
  • Using a dryer-style or extension cord that is undersized for your amperage.
  • Assuming the problem is the RV when the campground pedestal is faulty.
  • Ignoring a warm plug or cord, which can worsen into a fire hazard.
  • Running the AC and electric water heater at the same time on a 30-amp hookup.
  • Digital multimeter: lets you check voltage at the pedestal, the converter output and the battery bank. View on Amazon
  • Portable RV surge protector: guards against bad pedestal power and tells you when conditions are unsafe. View on Amazon
  • Replacement RV power cord: useful if the existing cord shows heat damage or worn prongs. View on Amazon

FAQ

Why does my RV power shut off only when the AC is running?

The air conditioner has a high startup surge, and combined with other loads it can exceed your service rating. Run the AC alone first, then add other appliances to see where the limit sits.

Can a bad campground pedestal damage my RV?

Yes, low voltage, reversed polarity and open grounds can harm appliances. A surge protector or power management system helps protect against this.

When should I call a professional?

If you see scorching, smell burning, or find a fault you cannot clear, stop using the hookup and consult a qualified RV technician or electrician before continuing.

Conclusion

Work through the source, breakers, load, cord, converter and protection devices in that order, and most shutdowns reveal their cause quickly. Keep loads staggered and cords in good condition, and your RV power should stay steady through the night.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our off-grid power for camping, RV & vanlife guides, checking product details against manufacturer specifications and owner feedback.