Updated November 2026
RV 50 amp power cord storage comes down to three things: keeping the cord dry, keeping the plug ends protected, and storing it without kinks or stress on the conductors. Follow the steps below and your cord will be ready to plug in at the next campsite, with fewer surprises at the pedestal.
Why Storage Matters for a 50 Amp Cord
A 50 amp shore power cord is heavy, stiff, and expensive to replace. Grit, moisture and crushed insulation are the usual causes of early failure, and most of that damage happens between trips rather than during them. Good 50 amp RV power cord storage habits protect the conductors, the plug housings and the locking rings.
Shopping for one? See our guide: 7 Best 50 Amp RV Power Cord Twist Lock Options for Campers (2026).
Step-by-Step Cord Storage Process
- Unplug from the pedestal first. Disconnect the RV end, then the pedestal end, so you never pull on a energized connection.
- Wipe down both plugs. Use a dry cloth to remove dirt, sand and dew. Check the pins for discoloration or pitting.
- Dry the cord completely. If it was wet, let it air dry before coiling. Coiling a damp cord traps moisture and invites corrosion.
- Coil in loose loops. Use a over-under method, roughly 3 to 4 feet per loop, so the cord lies flat without twisting. Avoid tight coils with a small bend radius.
- Secure the coil with hook-and-loop straps. Cinch them snug, not tight enough to dent the jacket.
- Cap both plug ends. Use the original plug covers or a clean rubber cap to keep dust out of the contacts.
- Store off the floor and out of direct sun. Hang the coil on a hook or place it in a rigid bin. UV exposure hardens and cracks cord jackets over time.
Choosing a Storage Method
How you store the cord depends on your compartment layout and how often you move the rig. Some campers keep the cord in a dedicated bay, others use a cord reel mounted near the hookup. Consult your RV manufacturer’s guidance before modifying a storage bay, especially if it sits near the electrical inlet.
| Storage method | Best for | Main benefit |
|---|---|---|
| Hanging coil on a hook | Garage or basement bays | Keeps the cord off the floor |
| Rigid storage bin | Shared or dusty compartments | Blocks dirt and sunlight |
| Motorized or manual reel | Frequent setups | Faster deployment and retrieval |
Common Mistakes to Avoid
- Coiling the cord while it is wet or warm from use.
- Wrapping the cord tightly around the RV’s bumper or stabilizer jacks.
- Leaving plug ends uncovered in a compartment that gets dusty or damp.
- Dragging the plug across gravel or pavement to reach the pedestal.
- Storing the cord near fuel, solvents or chemicals that can degrade the jacket.
Recommended gear
A few inexpensive accessories make 50 amp RV power cord storage easier to maintain. A reusable hook-and-loop strap set keeps coils tidy without pinching the jacket, which is why many campers keep a few on hand. A sealable plastic storage tote shields the cord from dust and moisture in a shared bay, and a plug cover set keeps the contacts clean between trips.
- Reusable hook-and-loop cable ties to secure coils: View on Amazon
- Weatherproof plastic storage tote for RV compartments: View on Amazon
- Rubber plug caps for RV power cord ends: View on Amazon
Tips for Longer Cord Life
- Inspect the cord and both plugs before every trip, looking for cracked jackets, scorched pins or loose strain reliefs.
- Store the cord at moderate temperatures; extreme heat and freezing both stress the jacket.
- If you use a cord reel, see 50 Amp RV Power Cord Reel Motorized: How to Choose and Use One for setup details.
- For a broader overview of cord types and lengths, read Rv Power Cable 50 Amp: Which Cord Should You Choose? (2026).
- When a cord shows damage, Replacing RV Power Cord: 30 Amp vs 50 Amp Options (2026) explains your replacement choices.
FAQ
Can I store my 50 amp RV power cord outdoors?
It is better to store it indoors or in a sealed, shaded compartment. Prolonged UV and rain exposure can crack the jacket and corrode the plug contacts.
How should I coil a 50 amp cord without damaging it?
Use loose over-under loops rather than tight, uniform coils. Avoid sharp bends near the plugs, since that is where strain and fatigue usually start.
Should I unplug the cord before packing it away?
Yes. Always disconnect the RV end and the pedestal end before handling the cord. If you have doubts about wiring or the inlet, consult a qualified RV technician.
Conclusion
Good RV 50 amp power cord storage is mostly about dryness, loose coils and protected plugs. A consistent routine takes only a few minutes and can add years to the cord’s life. Inspect it each time you store it, and address any damage before your next trip.

